Siemens SIMOTION D4x5-2 Commissioning And Hardware Installation Manual page 172

Commissioning (software)
7.1 Overview of commissioning
Requirement
Symbolic assignment is supported by the TO axis, TO externalEncoder and the TO outputCam,
TO camTrack and TO measuringInput. The onboard I/Os of a SIMOTION D, of a
SINAMICS S110/S120 control unit as well as from a TB30 and selected Terminal Modules can
be interconnected symbolically.
Table 7-1
Module
SIMOTION D410-2
SIMOTION D410
SIMOTION D4x5‑2
SIMOTION D4x5
Controller extension
● CX32‑2
● CX32
SINAMICS S110 CU305
SINAMICS S120
● CU310-2
● CU310
● CU320‑2
● CU320
See also
Only the drive configuration by means of symbolic assignment is described in this
documentation.
On the Internet, you can find documentation of older SIMOTION versions at:
support.industry.siemens.com/cs/ww/en/view/40211807)
For further information on the configuration of the TO axis and TO externalEncoder, see the
TO Axis Electrical/Hydraulic, External Encoder Function Manual.
172
Control units that support a symbolic assignment
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
Supports symbolic assignment
As of SIMOTION V4.3
As of SIMOTION V4.2
As of SIMOTION V4.2
As of SIMOTION V4.2
As of SIMOTION V4.2
As of SINAMICS V4.3
● As of SINAMICS V4.4
● As of SINAMICS V2.6.2
● As of SINAMICS V4.3
● As of SINAMICS V2.6.2
(https://
SIMOTION D4x5-2