Configuring Components - Siemens SIMOTION D4x5-2 Commissioning And Hardware Installation Manual

7.2.3

Configuring components

Requirement
You have inserted a SIMOTION D4x5‑2 into the project, configured the communication and
called the drive wizard by double-clicking "Configure drive unit" in the project navigator.
Note
An overview of permissible configurations, quantity structures and DRIVE-CLiQ topologies can
be found in the
(Page 327).
It should be noted, for example, that mixed operation of servo and vector is not possible,
although mixed operation of servo and vector
Failure to comply with the rules listed in this manual will result in errors that are not output until
the download is performed, rather than at the configuration stage.
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
SINAMICS S120 Commissioning Manual and in Section Quantity structures
7.2 Performing the configuration for the D4x5-2 offline
V / f is possible.
Commissioning (software)
177