Mounting The Simotion D4X5-2 With Spacers - Siemens SIMOTION D4x5-2 Commissioning And Hardware Installation Manual

Mounting and installation aids
The Control Unit is designed for mounting in a control cabinet (IP20 degree of protection). All
versions of SIMOTION D4x5‑2 are supplied with pre-assembled spacers for installation on the
wall of the control cabinet. The spacers can be removed if necessary.
Figure 3-1
See also
Mounting the SIMOTION D4x5-2 with spacers (Page 37)
3.2.2

Mounting the SIMOTION D4x5-2 with spacers

By using spacers, you can attach the control unit to a bare, metallic rear wall of a control cabinet
with good electrical conductivity with two M6 screws.
Purpose of this type of installation
This type of mounting is needed if:
● The heat is to be dissipate within the control cabinet
● The mounting depth of the SINAMICS S120 booksize grouping is to be achieved
The spacers are included in the scope of delivery of a control unit and are preassembled.
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
Mounting aids on the D425‑2 DP/PN and D445‑2 DP/PN
3.2 Installing the SIMOTION D4x5-2
Installing
37