Siemens SIMOTION D4x5-2 Commissioning And Hardware Installation Manual page 335

A detailed, regularly updated list of the DRIVE-CLiQ components approved for use with
SIMOTION, as well as notes on their use, can be found on the Internet at
support.industry.siemens.com/cs/ww/en/view/11886029).
If incorrect components are used, a topology error is signaled
F01360 Topology: Actual topology not permitted.
CX32‑2
The tables below provide an overview of the possible combinations:
Table 7-23
Controller extension
CX32
CX32‑2
Only approved combinations can be configured. If physically an incorrect controller extension
is used, a topology error is signaled.
F01360 Topology: Actual topology not permitted
CBE30‑2
The tables below provide an overview of the possible combinations:
Table 7-24
Communication
Board Ethernet
CBE30
CBE30‑2
Only approved combinations can be configured. If physically an incorrect
Communication Board Ethernet is used, the CBE cannot be fully inserted into the option slot.
CF card
A CF card with D4x5 firmware / drive software cannot run on a D4x5‑2. The same applies for
the reverse situation.
In case of an error, the 6 LED displays (RUN to DP/MPI) flash yellow at 2 Hz.
Licenses
Licenses purchased for SIMOTION D can be used for both the D4x5 and D4x5‑2.
Previously used platform-specific "MultiAxes Package for D445/D445‑1" licenses can also be
used for the D445‑2 DP/PN and D455‑2 DP/PN.
A new license has not been introduced for the D455‑2 DP/PN performance class.
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
Controller extension combinations
Article number
6SL3040-0NA00-0AA0
6AU1432-2AA00-0AA0
Communication Board Ethernet combinations
Article number
6FC5312-0FA00-0AA0
6FC5312-0FA00-2AA0
7.22 Migration of SIMOTION D4x5 to SIMOTION D4x5-2
Use in D4x5
Possible
Not possible
Use in D4x5
Possible
Not possible
Commissioning (software)
(https://
Use in D4x5-2
Not possible
Possible
Use in D4x5‑2
Not possible
● D4x5-2 DP/PN: As of V4.3
● D4x5-2 DP: Not possible
335