Siemens SIMOTION D4x5-2 Commissioning And Hardware Installation Manual page 45

Mounting the CX32‑2 directly on a Line Module in booksize format
The CX32‑2 can be mounted on the side wall of a SINAMICS S120 Line Module. The mounting
fixtures required for this are supplied with the SINAMICS S120 Line Module.
For more information on mounting the mounting elements, see also Section Fixing elements
(Page 41).
The SINAMICS S120 Line Module has five mounting fixtures on the left side. To mount the
control unit, proceed as follows (the steps are shown in the figure):
1. Attach the CX32‑2 to the left side of the SINAMICS S120 Line Module. Position the CX32‑2
a few millimeters higher than the Line Module. The mounting fixtures fit exactly in the five
cutouts on the module.
2. Push the two units together.
3. Press down on the module until the unit engages and is securely connected to the
SINAMICS S120 Line Module.
The module is now flush with the Line Module at the top and front.
1
Figure 3-8
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
Steps in mounting the CX32‑2 on a booksize Line Module
3.3 Installing supplementary system components
3
2
Installing
45