Toshiba ST-B10 Series Maintenance Manual page 94

5. DIAGNOSTIC TEST OPERATION
NOTE: Regarding the Send IP Address to be listed in the drop-down list box, it is programmable by
changing the data of the file "ping.txt" stored in the directory "/root/base/diag" of the USB memory.
Format of the file "ping.txt"
(It can be edited by either Linux or Windows.)
Example)
157.69.15.110
157.69.15.111
157.69.15.112
157.69.15.113
157.69.15.114
END
(2) Error code
Result Error Code
1
-1
-1
-1
LAN Test Error Code Table
Value
Under 1000 Error code returned from the system
1000 Parameter error
1001 INI file operation error
1002 route command execution error
(3) Corrective action
Error
MAC address acquiring error
PING setting item error
PING execution error
<< Preliminary version >>
• Be sure to input the IP address in each line.
• Any numeric values can be inputted.
• An ineffective IP address can be inputted, however, an error occurs at
the data transmission.
(Be sure to input an effective IP address.)
The data should be ended with END.
(If the [Enter] key is depressed after END, END is programmed in the
PING list. Therefore, do not depress the [Enter] key after END.)
Error Code Ex
0
1
2
2
Error
• The device may be damaged.
• Wrong data has been inputted to the PING setting item.
• Input proper data.
• Send IP Address is wrong.
• Set a proper IP address.
0 The test is terminated successfully. Or it is
terminated by selecting the [OK] button when
no error occurs.
0 MAC address acquiring error
1 PING setting item error
2 PING execution error
Cause & Measure
5- 32
5.4 Serviceman Diagnostic Test Program
Remarks
EO18-12017