Internal Paging Group Settings - NEC SL2100 Programming Manual

SL2100
Level:
IN
Description
Use Program 31-03 : Internal Paging Group Settings to assign names to Internal Paging Groups
Program
(i.e., Page Zones) and to define the splash tone for Internal Paging.
31 The system shows the names you program on the telephone display. Use the following chart when
entering and editing text. When using the keypad digits, press the key once for the first character,
twice for the second character, etc. For example, to enter a C, press 2 three times. Press 2 six times to
display the lower case letter.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit ...
Clear/Back or DND (2W
Digital/IP Multiline Terminal)
Flash
Input Data
Item
No.
01 Internal Paging Group
Name
2-356

31-03 : Internal Paging Group Settings

1 Enter characters : 1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters : A-C, a-c, 2.
3 Enter characters : D-F, d-f, 3.
4 Enter characters : G-I, g-i, 4.
5 Enter characters : J-L, j-l, 5.
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters :
*
# # = Accepts an entry (only required if two letters on the same key are needed - ex : TOM).
Pressing # again = Space. (In system programming mode, use the right arrow soft key instead
to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
Internal Paging Group Number
Item Input Data
Up to 12 Characters
Program 31 : Paging Setup
Key for Entering Names
When you want to ...
Á À Â Ã Å Æ Ç É Ê ì ó 0
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
Description
Assign name to Internal Paging Groups
(i.e., Page Zones). The system shows the
name you program on the telephone dis-
play.
ISSUE 2.0
1 ~ 50
Default
Refer below
Program 31 : Paging Setup