8-Pin Bdm Port; Target V - HP 16600A Series User Manual

Chapter 6: Connecting and Configuring the Emulation Module
Designing a Target System for the Emulation Module

8-pin BDM port

An 8-pin BDM port should be a dual row header strip ("Berg
connector"), 4 pins per row, 10 pins per inch, with 25 mil pins. If you
plan to use the 10-pin cable, use a header with 2 rows of 5 pins.
If you plan to make an 8-pin cable, you should use the following pin
assignments for the BDM port:
10-pin BDM port
If you plan to use the provided 10-pin cable, you should use the
following pin assignments for the BDM port:

Target V

DD
The emulator may draw up to 10 mA from target V .
DD
See page 236 for more information on current and voltage
requirements.
132 Solutions for CPU32