HP 16600A Series User Manual page 202

control-c.
Examples
To see the speed that the emulation module is using to
communicate with the target system you would issue the following
command in the SingleStep command window:
control -c "cf procck"
To change the speed to match a 25MHz processor clock you would
issue the following command in the command window:
control -c "cf procck=25"
For more information about "terminal interface" commands see page
148.
Download performance
Downloads are fastest when the emulation module speed is set to
match that of the target processor. The initial speed that the emulation
module uses to communicate with the target processor is set by the
Processor clock item in the connection tab of the "Debug" dialog. The
user is responsible for specifying this speed to be less than or equal to
the initial, reset, speed of the processor. Usually a command in the
_config alias will raise the speed of the processor above its initial, reset
value. For maximum download performance the command to increase
the target processor speed should be followed by a command to
increase the speed of the emulation module communication:
Example
After setting the clock rate of the target processor, the following
command should be entered to increase the emulation module
communication speed:
control -c "cf procck=25"
Solutions for CPU32
Chapter 8: Using the Emulator with a Debugger
Using the Software Development Systems debugger
201