To Connect The Transition Board - HP 16600A Series User Manual

CAUTION:

To connect the transition board

The microcontroller-specific transition board properly routes the
signals from the probe adapter to the analysis probe. To connect the
transition board to the analysis probe:
• Verify that there are no bent pins on the PGA socket of the analysis probe.
• Align the beveled corner of the transition board with the pin A1 corner of
the PGA connector on the underside of the analysis probe. The illustration
below shows the beveled corner and the pin A1 corner, as seen from the
top of the analysis probe.
Serious damage to the target system or analysis probe can result from
incorrect connection. Note the position of pin 1 (or pin A1) on the target
system, transition board, and the analysis probe prior to making any
connection. Also, take care to align the analysis probe connector with the pins
on the probe adapter assembly so that all pins are making contact.
Once all pins are aligned correctly, firmly press the transition board
onto the analysis probe PGA socket. You might need a solid surface to
press against.
Pin A1 Corner and Transition Board Alignment
Solutions for CPU32
Chapter 3: Connecting and Configuring the Analysis Probe
Connecting the Analysis Probe to the Target System
43