HP 16600A Series User Manual page 192

3 In the Target window, type:
4 Repeat steps 5 through 8 in the "Getting started" section to
• In the Debugger window, select
See Also
NOTE: logging commands in this way may result in a VERY large file.
Beware of the disk space it may require.
To reinitialize the system
If you suspect that the emulation module is out of sync with the MULTI
debugger, you may want to reinitialize it. Perform the steps below to
accomplish reinitialization:
init -c
configure the emulation module.
To disconnect from the emulation module
The Debugger command pane indicates that the debugger has
disconnected from the emulation module.
Error conditions
"!ERROR 800! Invalid command: bcast"
usually means that there is not a target interface module (TIM)
connected to the emulation module or the emulation module does not
have firmware for the CPU32 family. Verify that the emulation module
is connected to the target. Next, go to the system window of the logic
analyzer interface and verify that the Emulation Module icon (stop-
light) is described as a Motorola CPU16/32 BDM Emulator. If it is not,
follow the steps on page 144 to update the firmware in the emulation
module.
"command socket connection failed: WSAECONNREFUSED: connection refused"
usually means the emulation module is not at port #6470 on the Logic
Analysis System.
Green Hills MULTI Software Development Environment User's
Solutions for CPU32
Chapter 8: Using the Emulator with a Debugger
Using the Green Hills debugger
Remote©Disconnect
.
191