Chapter 3: Connecting and Configuring the Analysis Probe
Configuring the Logic Analysis System
Configuring the Logic Analysis System
You configure the logic analyzer by loading a configuration file. The
information in the configuration file includes:
• Label names and channel assignments for the logic analyzer
• Inverse assembler file name
The configuration file you use is determined by the logic analyzer you
are using. The configuration file names are listed with the logic
analyzer connection tables, and in a table at the end of this section.
The procedures for loading a configuration file depend on the type of
logic analyzer you are using. There is one procedure for the HP 16600/
700 series logic analysis systems, and another procedure for the
HP 1660-series, HP 1670-series, and logic analyzer modules in an
HP 16500B/C mainframe. Use the appropriate procedures for your
analyzer.
Solutions for CPU32
83