To Connect To A Target System Via An 8-Pin Debug Port - HP 16600A Series User Manual

CAUTION:
6 Turn on the power to the logic analysis system, then turn on the
See Also
1 Remove power from the target system and the emulator.
2 Plug one end of the 50-pin cable into the emulator.
3 Plug the other end of the 50-pin cable into the target interface
Be careful to orient the connector as shown below. If the connector is rotated,
your target system or the emulation module may be damaged.
power to the target system.
"Designing a Target System for the Emulation Module" on page 130.
To connect to a target system via an 8-pin
debug port
module.
Solutions for CPU32
Chapter 6: Connecting and Configuring the Emulation Module
Connecting the Emulation Module to the Target System
141