Setting The Correction Of Cross-Interference - Siemens SIPROCESS GA700 Operating Manual

Functions
6.9 [2.10] Settings > Correction of cross-interferences
6.9.5

Setting the correction of cross-interference

Procedure
1. Component > Main menu > "2. Settings" > "10. Correction of cross-interference"
The menu includes six navigation lines that you use to set or activate the correction of
cross-interferences for the selected component. The menu entries are structured as
follows:
1)
2)
3)
4)
2. Assign constant correction of cross-interference or variable correction of cross-
interference.
– Assigning correction of cross-interference with a constant (Page 169)
– Assigning variable correction of cross-interference (Page 170)
3. Totally enable/disable assigned corrections of cross-interferences.
– Enabling/disabling all corrections of cross-interferences (Page 179)
See also
Setting instructions (Page 166)
Correction of cross-interference in the application "H2 in N2 (Q)" for furnace gas, converter
gas and wood distillation (Page 175)
168
Structure of the navigation lines
1 Total
1)
2 Constant
3 ... 6 Source of cross-
3)
interference measured
value
Enable/disable all corrections of cross-interference
Determine and enable constant correction of cross-interference.
Variable corrections of cross-interference
Editing line
2)
Name of cross-
interference measured
value
Activation status (on/off)
Activation status (on/off)
Activation status (on/off)
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05
Edit
4)
Edit
4)
Edit
4)