[3.08] Maintenance & Diagnostics > Maintenance Intervals; Displaying Maintenance Intervals; Assigning Maintenance Interval Parameters - Siemens SIPROCESS GA700 Operating Manual

6.21 [3.08] Maintenance & Diagnostics > Maintenance intervals
6.21.1

Displaying maintenance intervals

Procedure
1. Main menu > "3. Maintenance & Diagnostics" > "8. Maintenance intervals"
This menu contains all user-assignable maintenance intervals. The menu entries are
structured as follows:
1)
2)
3)
4)
5)
6)
2. Check remaining runtimes: Remaining runtimes with the value "0" indicate that the
corresponding message (maintenance required, maintenance demanded, maintenance
alarm) has already been generated.
3. Set maintenance intervals: Assigning maintenance interval parameters (Page 227).
6.21.2

Assigning maintenance interval parameters

Procedure
Note
Sequence time/update of maintenance intervals
The maintenance intervals are always updated at midnight (00:00 hours): initially on the day
after the parameter assignment, then daily. If a maintenance interval expires, the message
"Maintenance interval expired" is output. This message is also output at midnight
(00:00 hours).
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05
Structure of the navigation lines
01. TAG
1)
2)
Menu entry number
Symbol of the highest message level
Designation of the maintenance interval
Remaining runtime of the maintenance required status in days
Remaining runtime of the maintenance demanded status in days
Remaining runtime of the maintenance alarm status in days
6.21 [3.08] Maintenance & Diagnostics > Maintenance intervals
5d
3) 4)
10d 20d
5) 6)
Functions
Edit ►
227