Functions
6.17 [3.03] Maintenance & Diagnostics > Logbook
6.16.3
Acknowledge all messages
Procedure
1. Main menu > "3. Maintenance & Diagnostics" > "2 Messages to be acknowledged" >
"2. Acknowledge all"
2. "Acknowledge all messages" parameter field
– Enter user pin
– There are no more messages in the message list.
3. If the message list still includes messages:
– Check to see if the cause of the message has been remedied: [3.01] Maintenance &
– Check or change the parameter assignment of the message system, if necessary:
Note
"USER FUNC" key
The factory default setting for the "USER FUNC" key is the "Acknowledge all messages"
function. If this function is still assigned, you can acknowledge all messages with one
keystroke. Additional information is available under: → AUTOHOTSPOT.
208
The acknowledgment is triggered immediately after the Standard PIN is entered.
Diagnostics > Current messages (Page 203).
Remedy the causes.
[2.14] Settings > Set message parameters (Page 187).
Operating with the Local User Interface
Operating Manual, 06/2017, A5E31930478-05