Siemens SIPROCESS GA700 Operating Manual page 62

Operation
4.3 Display
Header (parameter view)
Figure 4-6 Example of headers in parameter view
The header in the parameter view always includes the menu name and the corresponding
menu or order number. You can also read out the scope of the menu:
①
●
The header only includes the menu name/parameter name as well as the corresponding
order number. Any changed settings also apply to all other components.
②
●
In addition to the menu name/parameter name and the order number, the component
identification
components of a module.
③
●
Changes only have an effect on the component
currently assigning. Corresponding function(s) for further components must therefore
always be set separately.
62
Menu/parameter with effect on entire device:
Menu/parameter with module-specific effect:
④
(here: CO/CO
Menu/parameter with component-specific effect:
) is displayed. Any changed settings also apply to all
2
⑤
(here: O
Operating Manual, 06/2017, A5E31930478-05
) whose parameters you are
2
Operating with the Local User Interface