Panasonic KX-NS700 Feature Manual page 149

•
Message Waiting
While calls are forwarded, Message Waiting information is not forwarded. The Message button light turns
on at the originally called extension. (→ 13.1.3 Message Waiting)
•
Idle Extension Hunting
Idle Extension Hunting applies to calls forwarded to a busy extension in an idle extension hunting group.
•
Second Line LCD Display Information for ICD Group Redirected Call
If an incoming call distribution receives a redirected call, the second line of the PT receiving the call can
be set to display either of the following information, through system programming.
–
The extension number and name of the extension or ICD Group that originally received the call.
–
The floating extension number and name of the ICD Group currently receiving the call.
[All Calls and Busy]
•
If the forward destination is not available to answer a call, this feature is canceled and the original
destination will ring for the following type of call:
–
Doorphone call
–
CO line calls via the LCOT card
[No Answer and Busy/No Answer]
•
No Answer Time
The number of rings before the call is forwarded is programmable for each extension.
[Follow Me]
•
This feature is only available when the original extension has set "Remote Operation by Other
Extension" to "Allow" through COS programming.
[Parallel Ringing When Forwarding to CO Line]
•
KX-NSE101, KX-NSE105, KX-NSE110 or KX-NSE120 (Activation Key for Mobile Extension) is required to
use this feature. One activation key is required for each extension that will use this feature.
•
Even though DSS buttons for the forwarding extension indicate that the extension is busy, it can still
receive calls. If another call is received, FWD—No Answer will operate as normal.
•
It is possible to set the forwarding extension to busy through system programming.
•
When the forwarding extension is a virtual PS (→ 21.1.2 Virtual PS)
–
The No Answer Time setting is ignored: All calls are forwarded immediately, even if No Answer is
specified as the forwarding method.
–
If the forward destination is unavailable, the forwarding extension is treated as busy. (In this case, FWD
—Busy is ignored even if it is enabled.) However, if the original caller is on an analog CO line, to which
busy signals/tones cannot be sent, the PBX will continue to try to connect to the forward destination
until a connection is established or the original caller hangs up.
–
It is possible to set the forwarding extension virtual PS to busy through ICD Group programming.
•
If an extension goes on-hook while transferring a call to an extension ringing in parallel with a CO line, the
CO line will stop ringing for a moment, then begin ringing again.
•
LCOT CO lines do not support this feature.
•
This feature may not be available depending on the specifications of the telephone network.
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—FWD No Answer Timer
Set
10.7.1 PBX Configuration—[2-7-1] System—Class of Service—COS Settings
Document Version 2017-06
7.1.7 FWD (Call Forwarding)
Feature Manual 149