Direct Sip Connection - Panasonic KX-NS700 Feature Manual

[Programming Example: DIL Table]
The table can be programmed for each CO line.
Port No.
(CO Line No.)
Day
01 Enable
02 Enable
→ 18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings—DIL—DIL Destination—Day, Lunch,
*1
Break, Night
In this example:
If a CO line call is received on CO line 01:
In day mode: Calling Line Identification (CLI) distribution is enabled. The call is routed to its CLI destination,
if assigned. If not assigned, the call is routed to the Direct In Line (DIL) destination, extension 101.
In lunch mode: CLI distribution is disabled. The call is routed to the DIL destination, extension 100.
Note
The following settings can also be specified in the DIL table:
•
Tenant number: determines the time mode (day/lunch/break/night) for the corresponding CO line.
•
UM service group number: determines the service group to use when a call is handled by the Unified
Messaging system.
•
VM trunk group number: used in Voice Mail DPT (Digital) Integration with a VPS.
Conditions
•
To use this feature, DIL must be assigned as the distribution method for the desired CO line port.
PC Programming Manual References
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings—DIL
→DIL Destination—Day, Lunch, Break, Night
→Tenant Number
→UM Service Group No.
→VM Trunk Group No.
PT Programming Manual References
[450] DIL 1:1 Destination
Feature Manual References
4.1.14 CLI (Calling Line Identification) Distribution
10.1.11 INCOMING CALL FEATURES
19.1.3 Time Service
20.1.71 Unified Messaging—Service Group

5.1.9 Direct SIP Connection

Description
Using this feature, the PBX can be used as a gateway to connect with services provided by external SIP
servers.
Document Version 2017-06
CLI Distribution
Lunch Break Night
Disable Enable Disable
Disable Disable Disable
DIL Destination
Day Lunch Break
101 100 101
102 100 102
5.1.9 Direct SIP Connection
*1
Night
100
100
Feature Manual 91