Table of Contents
Advertisement
4.INSTALLATION
3) Others
When using heat generating equipment such as the regenerative brake option, install them
with full consideration of heat generation so that the servo amplifier is not affected.
Install the servo amplifier on a perpendicular wall in the correct vertical direction.
(2) Keep out foreign materials
1) When installing the unit in a control box, prevent drill chips and wire fragments from entering
the servo amplifier.
2) Prevent oil, water, metallic dust, etc. from entering the servo amplifier through openings in
the control box or a fan installed on the ceiling.
3) When positioning the control panel in a place where there is much harmful gas or dust,
perform an air purge (force-feed clean air from the outside of the control panel to increase
the inside air pressure more than the outside air pressure) to prevent harmful gas or dust
from entering the control panel.
4– 4
Advertisement
Table of Contents
