Table of Contents
Advertisement
4. Additional instructions
The following instructions should also be fully noted. Incorrect handling may cause a fault, injury,
electric shock, etc.
(1) Transportation and installation
Transport the products correctly acordng to their weights.
Stacking in excess of the specified number of products is not allowed.
Do not carry the motor by the cables, shaft or encoder.
Do not hold the front cover to transport the controller. The controller may drop.
Install the servo amplifier in a load-bearing place in accordance with the Installation guide.
Do not climb or stand on servo equipment. Do not put heavy objects on equipment.
The controller and servo motor must be installed in the specified direction.
Leave specified clearances between the servo amplifier and control enclosure walls or
other equipment.
Do not install or operate the servo amplifier and servo motor which has been damaged or
has any parts missing.
Provide adequate protection to prevent screws and other conductive matter, oil and other
combustible matter from entering the servo amplifier.
Do not drop or strike servo amplifier or servo motor. Isolate from all impact loads.
CAUTION
– 3 –
Advertisement
Table of Contents
