Toshiba MJ-1104 Service Manual page 103

[G] EFS unit
(1) Take off the folding drive unit.
 P.4-33 "[F] Folding drive unit"
(2) Release the harness out of 9 clamps, and
then disconnect the connector of CN18 on
the SDL board.
(3) Disconnect each connector of CN4, CN15
and CN19 on the SDL board. Break binding
wire at one position and release the harness
from 7 clamps.
(4) Release the harness out of 3 clamps.
Disconnect the connector of the stacker
home position sensor. Disconnect the relay
connector of the stacker motor. Disconnect
the relay connector of the saddle tray paper
detection sensor.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Clanp
Fig. 4-97
Binding
wire
Fig. 4-98
Clamp
Fig. 4-99
4 - 35
SDL board
SDL board
Clamp
Clamp
connctor
relay connector
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4