Toshiba MJ-1104 Service Manual page 133

[C] Paddle motor (M3)
(1) Take off the rear cover.
 P.4-6 "[G] Rear cover"
(2) Disconnect all the connectors of the FIN
board and then release the harness from the
clamp.
(3) Remove 4 screws from the FIN board
bracket.
(4) Release the harness of the paddle motor out
of the clamp.
(5) Remove 2 screws, and then take off the pad-
dle motor.
[D] Buffer roller drive motor(M4)
(1) Take off the control panel unit.
 P.4-3 "[D] Control panel unit"
(2) Take off the stationary tray.
 P.4-1 "[A] Stationary tray"
(3) Take off the the belt to pulley of the buffer
roller drive motor.
(4) Remove 2 screws, and then disconnect the
connector to take off the buffer roller drive
motor.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-183
Fig. 4-184
Connector
Buffer roller drive motor
Fig. 4-185
4 - 65
Bracet
Clamp
Paddle motor
Belt
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4