Toshiba MJ-1104 Service Manual page 124

[I] Upper exit roller / Upper exit roller guide
(1) Take off the rear upper cover.
 P.4-6 "[G] Rear cover"
(2) Take off the control panel unit.
 P.4-3 "[D] Control panel unit"
(3) Remove 2 screws, and then take off the front
and rear stays and 2 spacers.
Note:
Be careful not to damage the harness con-
nected to the stationary tray transport
guides.
(4) Loosen 2 screws each for the front and rear
stationary tray discharge brush.
(5) Remove 4 screws and take off the front and
rear stationary tray transport guides.
Note:
Be careful not to damage the harness of
entrance sensor.
Note:
When installing the front and rear stationary
tray transport guides, fix them at the posi-
tions where the gap between the trailing
edges of the guides and the frame is 1 mm.
Check if the flap and the upper exit roller
move smoothly after screws are tightened.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Spacer
Stay
Stationary tray transport guide
Stationary tray
transport guide
1mm
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 56
Stay
Spacer
Fig. 4-156
Stationary tray
discharge brush
Fig. 4-157
Fig. 4-158