Toshiba MJ-1104 Service Manual page 150

(3) Remove 2 screws, and then take off the
catching solenoid.
[F] Buffer roller lift solenoid (SOL2) / Patting solenoid (SOL3)
(1) Take off the stationary tray.
 P.4-1 "[A] Stationary tray"
(2) Close the buffer unit-1.
(3) Release the harness of the buffer roller lift
solenoid and the patting solenoid out of 1
clamp, and then disconnect 2 relay connec-
tors.
(4) Remove 3 screws, and then disconnect the
plunger to take off the 3 spacers, 3 screw
dampers, 2 solenoid dampers and solenoid
sensor unit.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Relay
connector
Clamp
Solenoid sensor unit
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 82
Catching solenoid
Fig. 4-231
Fig. 4-232
Spacer
Screw
damper
Solenoid
damper
Fig. 4-233