Toshiba MJ-1104 Service Manual page 146

[E] Additional folding motor (M20)
(1) Take off the EFS unit.
 P.4-35 "[G] EFS unit"
(2) Disconnect the connector of the additional
folding motor encoder sensor.
(3) Break the binding wire at 1 position and
release the harness from the clamp.
(4) Remove the 1 clip.
(5) Remove 2 screws and take off the gear
bracket and pulley.
(6) Remove 2 screws and take off the belt and
additional folding motor.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Clamp
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 78
Connecter
Binding wire
Fig. 4-219
Clip
Pulley
Gear bracket
Fig. 4-220
Belt
Additional folding motor
Fig. 4-221