Toshiba MJ-1104 Service Manual page 137

(4) Remove 2 screws, and then disconnect the
connector to take off the stapler unit shift
motor.
[J] Paper pusher arm motor(M10)
(1) Take off the stationary tray.
 P.4-1 "[A] Stationary tray"
(2) Disconnect all the connector of the paper
pusher home position sensor.
(3) Release the harness from the 1 clamp.
(4) Disconnect the relay connector of the paper
pusher arm motor and then release the har-
ness from the 2 clamps.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-195
Fig. 4-196
Relay
connector
Clamp
Fig. 4-197
4 - 69
Stapler unit
shift motor
Connecter
Clamp
Clamp
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4