Toshiba MJ-1104 Service Manual page 83

[B] Buffer unit
(1) Take off the stational tray cover.
 P.4-1 "[A] Stationary tray"
(2) Take off the junction box unit.
 P.4-13 "[A] Junction box unit"
(3) Take off the front rail cover and rear rail
cover.
 P.4-9 "[M] Front rail cover / Rear rail
cover"
(4) Remove 2 screws, and then take off the front
rail guide.
(5) Remove 2 screws, and then take off the rear
rail guide.
(6) Release the harness leading from other units
from 3 clamps.
(7) Release the harness out of 2 clamps, and
then disconnect the connector of the
entrance motor.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Rear rail guide
Fig. 4-41
Clamp
Fig. 4-42
Entrance motor
Connector
Fig. 4-43
4 - 15
Front rail guide
Clamp
Clamp
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4