Toshiba MJ-1104 Service Manual page 149

(3) Take off the gear bracket. Disconnect the
relay connector, and then take off the1 bear-
ing and folding blade clutch.
Note:
When installing the folding blade clutch,
attach a rotation protection.
[D] Paper holding clutch (CLT4) (MJ-1104)
(1) Open the front upper cover and then pull out
the saddle unit.
(2) Disconnect the relay connector, and then
release the harness from the clamp.
(3) Remove 1 E-ring , and then take off the
paper holding clutch.
Note:
When installing the paper holding clutch,
attach a rotation protection.
[E] Catching solenoid (SOL1)
(1) Take off the junction box unit.
 P.4-13 "[A] Junction box unit"
(2) Disconnect the connector of the CN23 on the
FIN board, and then release the harness out
of 4 clamps.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Bearing
Folding blade
clutch
Fig. 4-228
Paper holding clutch
Fig. 4-229
Fig. 4-230
4 - 81
Gear bracket
FIN board
Clamp
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4