Toshiba MJ-1104 Service Manual page 164

[H] Rear alignment plate home position sensor (S8)
(1) Take off the grate-shaped guide.
 P.4-10 "[N] Grate-shaped guide"
(2) Release the latch, and then disconnect the
connector to take off the rear alignment plate
home position sensor.
[I] Stack exit belt home position sensor (S9)
(1) Take off the finishing tray unit.
 P.4-19 "[D] Finishing tray unit"
(2) Remove 3 screws, and then take off the front
finishing tray cover.
(3) Remove 3 screws, and then take off the rear
finishing tray cover.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Rear alignment
plate home position sensor
Rear finishing tray cover
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 96
Fig. 4-270
Front finishing tray cover
Fig. 4-271
Fig. 4-272