Troubleshooting Packet Loss; Displaying Drop Counters - Dell Force10 C150 Configuration Manual
Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs
Also See for Force10 C150:
- Manual (57 pages) ,
- Manual (66 pages) ,
- Quick start manual (33 pages)
Table of Contents
Advertisement
Figure 62-9. Single Queue Application for S50N with Default Packet Pointers
!
buffer-profile fp fsqueue-fp
buffer dedicated queue0 3 queue1 3 queue2 3 queue3 3 queue4 3 queue5 3 queue6 3 queue7 3
buffer dynamic 1256
!
buffer-profile fp fsqueue-hig
buffer dedicated queue0 3 queue1 3 queue2 3 queue3 3 queue4 3 queue5 3 queue6 3 queue7 3
buffer dynamic 1256
!
buffer fp-uplink stack-unit 0 port-set 0 buffer-policy fsqueue-hig
buffer fp-uplink stack-unit 0 port-set 1 buffer-policy fsqueue-hig
!
Interface range gi 0/1 - 48
buffer-policy fsqueue-fp
FTOS#sho run int gi 0/10
!
interface GigabitEthernet 0/10
no ip address
Troubleshooting packet loss
show hardware stack-unit
The
packet loss. FTOS 7.7.1.1 augmented the statistics reported by existing command options (see
Statistics on page
those counters, as listed here:
•
show hardware stack-unit cpu data-plane statistics
•
show hardware stack-unit cpu party-bus statistics
•
show hardware stack-unit 0-7 drops unit 0-1 port 0-27
•
show hardware stack-unit 0-7 stack-port 0-52
show hardware stack-unit 0-7 unit 0-1 {counters | details | port-stats [detail] | register}
•
•
show hardware {layer2| layer3} acl stack-unit 0-7 stack 0-1
•
show hardware layer3 qos stack-unit 0-7 port-set 0-1
•
show hardware system-flow layer2 stack-unit 0-7 port-set 0-1 [counters]
•
clear hardware stack-unit 0-7 counters
•
clear hardware stack-unit 0-7 unit 0-1 counters
•
clear hardware stack-unit 0-7 cpu data-plane statistics
•
clear hardware stack-unit 0-7 cpu party-bus statistics
•
clear hardware stack-unit 0-7 stack-port 0-52
Displaying Drop Counters
show hardware stack-unit 0–7 drops [unit 0–1 [port 0–27]]
The
unit, port pipe, and port is experiencing internal drops, as shown in
1232
|
S-Series Debugging and Diagnostics
command, introduced in FTOS 7.7.1.0 is intended primarily to troubleshoot
1234), added commands and command options, and added
clear
commands to refresh
command assists in identifying which stack
Figure 62-10
and
Figure
Dataplane
:
62-11.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
