Dell Force10 C150 Configuration Manual page 830

Figure 38-12
show monitor session
the
remote-vlan 22) and the destination is the destination port (for example, Gi 4/73) to which an analyzer is
attached.
Figure 38-12. Configuring Remote Port Mirroring: Destination Switch
FTOS(conf)#interface vlan 22
FTOS(conf-if-vl-22)#mode remote-port-mirroring
FTOS(conf-if-vl-22)#tagged gi 4/48
FTOS(conf-if-vl-22)#no shutdown
FTOS(conf-if-vl-22)#exit
FTOS(conf)#monitor session 100
FTOS(conf-mon-sess-100)#source remote-vlan 22 destination gi 4/73
FTOS(conf-mon-sess-100)#tagged destination gi 4/73
FTOS(conf-mon-sess-100)#show config
monitor session 100
source remote-vlan 22 destination GigabitEthernet 4/73
FTOS(conf-mon-sess-100)#end
FTOS#show monitor session 100
SessionID
---------
100
830 | Port Monitoring
shows a sample configuration of remote port mirroring on a destination switch. Note that in
output of a destination session, the source is the reserved VLAN (for example,
Source
------
remote-vlan 22
Destination Direction
----------- ---------
Gi 4/73 N/A
Mode
----
Remote-Port-Mirroring
Type
----
N/A