Monitor And Debugging Lacp; Shared Lag State Tracking - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

Figure 24-4. Invoking the LACP Long Timeout
FTOS(conf)# interface port-channel 32
FTOS(conf-if-po-32)#no shutdown
FTOS(conf-if-po-32)#switchport
FTOS(conf-if-po-32)#lacp long-timeout
FTOS(conf-if-po-32)#end
FTOS# show lacp 32
Port-channel 32 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
LACP LAG 1 is an aggregatable link
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
I - Collection enabled, J - Collection disabled, K - Distribution enabled L - Distribution disabled,
M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired state,
P - Receiver is not in expired state
Port Gi 10/6 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ADEHJLMP Key 1 Priority 128
Note: View PDU exchanges and the timeout value using the command
Debugging LACP on page

Monitor and Debugging LACP

The system log (syslog) records faulty LACP actions.
To debug LACP, use the following command:
Command Syntax
no
[
] debug lacp [config | events | pdu
[in | out | [interface [in | out]]]]

Shared LAG State Tracking

Shared LAG State Tracking provides the flexibility to bring down a port channel (LAG) based on the
operational state of another LAG. At any time, only two LAGs can be a part of a group such that the fate
(status) of one LAG depends on the other LAG.
In
Figure
Traffic is equally distributed between LAGs 1 and 2. If LAG 1 fails, all traffic from R1 to R4 flows across
LAG 2 only. This condition over-subscribes the link, and packets are dropped.
546
|
Link Aggregation Control Protocol
546.
Command Mode
EXEC
24-5, line-rate traffic from R1 destined for R4 follows the lowest-cost route via R2, as shown.
debug lacp
Purpose
Debug LACP, including configuration and events.
. See
Monitor and

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents