Return To The Default Cam Configuration - Dell Force10 C150 Configuration Manual

Figure 11-9. Configuring Ingress Layer 2 ACL on the Entire System
FTOS(conf)#do show cam-l2acl | find "Line card 1"
-- Line card 1 --
Current Settings(in percent)
Sysflow :
L2Acl :
Pvst :
Qos :
L2pt :
Frrp :
[output omitted]
FTOS(conf)#cam-l2acl system-flow 100 l2acl 0 p 0 q 0 l 0 f 0
FTOS(conf)#do show cam-l2acl | find "Line card 1"
-- Line card 1 --
Current Settings(in percent)
Sysflow :
L2Acl :
Pvst :
Qos :
L2pt :
Frrp :
[output omitted]
FTOS(conf)#do copy run start
File with same name already exist.
Proceed to copy the file [confirm yes/no]: yes
!
8676 bytes successfully copied
02:00:49: %RPM0-P:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in flash by
default
FTOS(conf)#do show cam-l2acl | find "Line card 1"
-- Line card 1 --
Current Settings(in percent)
Sysflow :
L2Acl :
Pvst :
Qos :
L2pt :
Frrp :

Return to the Default CAM Configuration

Return to the default CAM Profile, microcode, IPv4Flow, or Layer 2 ACL configuration using the
default
keyword
6
14
50
12
13
5
6
14
50
12
13
5
6
14
50
12
13
5
from EXEC Privilege mode or from CONFIGURATION mode, as shown in
Next Boot(in percent)
100
5
5
5
5
5
Figure 11-10.
Content Addressable Memory | 297