Dell Force10 C150 Configuration Manual page 395

Figure 18-8. Determining your System Pre-requisites for Cache Boot
FTOS#show rpm
-- RPM card 0 --
Status
Next Boot
Card Type
Hardware Rev
Num Ports
Up Time
Last Restart
FTOS Version
Jumbo Capable : yes
CP Boot Flash : A: 2.4.1.1
RP1 Boot Flash: A: 2.4.1.1
RP2 Boot Flash: A: 2.4.1.1
CP Mem Size
RP1 Mem Size
RP2 Mem Size
MMC Mem Size
External MMC
Temperature
Power Status
Voltage
Serial Number : FX000017082
--More--
2. The cache boot feature requires at least the boot code versions in
linecard
commands to verify that you have the proper version
Table 18-5. Boot Code Requirements for Cache Boot
Component
E-Series TeraScale RPM
E-Series TeraScale Line Card
E-Series ExaScale RPM
E-Series ExaScale Line Card
C-Series RPM
C-Series Line Card
If you do not have the proper boot code version, the system displays a message similar to
you attempt to select a cache boot image (see
in the Release Notes for instructions on upgrading boot code.
Message 7 Boot Code Upgrade Required for Cache Boot Error
% Error: linecard 0 doesn't have cache boot aware bootCode.
: active
: online
: RPM - Route Processor Module (LC-EF3-RPM)
: 2.2i
: 1
: 1 day, 4 hr, 25 min
: reset by user
: 4.7.5.427
[booted]
: 536870912 bytes
: 1073741824 bytes
: 1073741824 bytes
: 520962048 bytes
: n/a
: 32C
: AC
: ok
Boot Code
2.4.2.1
2.3.2.1
2.5.0.3
2.9.0.5
2.7.1.1
2.6.0.1
Hardware Revision 2.1 or later
Specified boot code version
B: 2.4.1.1
B: 2.4.1.1 [booted]
B: 2.4.1.1 [booted]
(Figure
Select the Cache Boot
show rpm
Table 18-5. Use
18-8).
Message 7
Image). See Upgrading the Boot Code
High Availability | 395
show
and
when