Dell Force10 C150 Configuration Manual page 38

Table 2-1. FTOS Command Modes
CLI Command Mode
EXEC
EXEC Privilege
CONFIGURATION
Note: Access all of the following modes from CONFIGURATION mode.
ARCHIVE
AS-PATH ACL
Gigabit Ethernet
Interface
10 Gigabit Ethernet
Interface
Interface Range
Loopback Interface
Management Ethernet
Interface
Null Interface
Port-channel Interface
SONET Interface
VLAN Interface
STANDARD ACCESS-
LIST
EXTENDED ACCESS-
LIST
IP COMMUNITY-LIST
AUXILIARY
CONSOLE
VIRTUAL TERMINAL
38 | Configuration Fundamentals
Prompt
FTOS>
FTOS#
FTOS(conf)#
FTOS(conf-archive)
FTOS(config-as-path)#
FTOS(conf-if-gi-0/0)#
FTOS(conf-if-te-0/0)#
FTOS(conf-if-range)#
FTOS(conf-if-lo-0)#
FTOS(conf-if-ma-0/0)#
FTOS(conf-if-nu-0)#
FTOS(conf-if-po-0)#
FTOS(conf-if-so-0/0)#
FTOS(conf-if-vl-0)#
FTOS(config-std-nacl)#
FTOS(config-ext-nacl)#
FTOS(config-community-list)#
FTOS(config-line-aux)#
FTOS(config-line-console)#
FTOS(config-line-vty)#
Access Command
Access the router through the console or Telnet.
• From EXEC mode, enter the command
• From any other mode, use the command
• From EXEC privilege mode, enter the command
configure
.
• From every mode except EXEC and EXEC
Privilege, enter the command
archive
ip as-path access-list
interface
ip access-list standard
ip access-list extended
ip community-list
line
enable
.
end
.
exit
.