Radius - Dell Force10 C150 Configuration Manual

To specify a password for the terminal line, use the following commands, in any order, in the LINE mode:
Command Syntax
privilege level level
password
[
encryption-type
To view the password configured for a terminal, use the
Enable and disabling privilege levels
enable
Enter the
level. If you do not enter a privilege level, FTOS sets it to 15 by default.
To move to a lower privilege level, enter the command
set for the user in the EXEC Privilege mode. If you enter
level is 1.

RADIUS

Remote Authentication Dial-In User Service (RADIUS) is a distributed client/server protocol. This
protocol transmits authentication, authorization, and configuration information between a central RADIUS
server and a RADIUS client (the Dell Force10 system). The system sends user information to the RADIUS
server and requests authentication of the user and password. The RADIUS server returns one of the
following responses:
• Access-Accept—the RADIUS server authenticates the user
• Access-Reject—the RADIUS server does not authenticate the user
If an error occurs in the transmission or reception of RADIUS packets, the error can be viewed by enabling
debug radius
the
Transactions between the RADIUS server and the client are encrypted (the users' passwords are not sent in
plain text). RADIUS uses UDP as the transport protocol between the RADIUS server host and the client.
For more information on RADIUS, refer to RFC 2865,
Command Mode
LINE
] LINE
password
enable privilege-level
or
command.
Purpose
Configure a custom privilege level for the terminal
lines.
level level
•
pre-configured. Levels 2 to 14 are available for
custom configuration.
Specify either a plain text or encrypted password.
Configure the following optional and required
parameters:
• encryption-type: Enter 0 for plain text or 7 for
encrypted text.
• password
long.
show config
command in the EXEC Privilege mode to set a user's security
disable
followed by the
disable
Remote Authentication Dial-in User Service
range: 0 to 15. Levels 0, 1 and 15 are
: Enter a text string up to 25 characters
command in the LINE mode.
level-number
without a level-number, your security
you wish to
.
Security | 925