Dell Force10 C150 Configuration Manual page 936

FTOS supports both inbound and outbound SSH sessions using IPv4 or IPv6 addressing. Inbound SSH
supports accessing the system through the management interface as well as through a physical Layer 3
interface.
For details on command syntax, see the Security chapter in the FTOS Command Line Interface Reference.
SCP is a remote file copy program that works with SSH and is supported by FTOS.
Note: The Windows-based WinSCP client software is not supported for secure copying between a PC
and an FTOS-based system. Unix-based SCP client software is supported.
To use the SSH client, use the following command in the EXEC Privilege mode:
Command Syntax
ssh
{ hostname | hostip
-p
|
username port-number
2
}
To enable the SSH server for version 1 and 2, use the following command in the CONFIGURATION
mode:
Command Syntax
ip ssh server enable | port
{
To enable the SSH server for version 1 or 2 only, use the following command:
Command Syntax
ip ssh server version
To view the SSH configuration, use the following command in EXEC Privilege mode:
Command Syntax
show ip ssh
Figure 45-6 on page 937
show ip ssh
and the
936 | Security
Command Mode
-l
} [ EXEC Privilege
-v 1
| { |
port-number}
Command Mode
1|2
{ } CONFIGURATION
shows the use of the command
command to confirm the setting.
Purpose
Open an SSH connection specifying the hostname or
hostip , username, port number, and version of the SSH
client.
is the IP address of the remote device, which can
hostip
be an IPv4 address (A.B.C.D)or IPv6 address
(X:X:X:X::X).
Command Mode Purpose
CONFIGURATION Configure the Dell Force10 system as an
SCP/SSH server.
Purpose
Configure the Dell Force10 system as an SSH server that
uses only version 1 or 2.
Command Mode Purpose
EXEC Privilege Display SSH connection information.
ip ssh server version 2
to enable SSH version 2,