Configure Rip On Interfaces - Dell Force10 C150 Configuration Manual

When the RIP process has learned the RIP routes, use the
mode to view those routes
Figure 42-2. show ip rip database Command Example (Partial)
FTOS#show ip rip database
Total number of routes in RIP database: 978
160.160.0.0/16
160.160.0.0/16
2.0.0.0/8
2.0.0.0/8
4.0.0.0/8
4.0.0.0/8
8.0.0.0/8
8.0.0.0/8
12.0.0.0/8
12.0.0.0/8
20.0.0.0/8
20.0.0.0/8
29.10.10.0/24
29.0.0.0/8
31.0.0.0/8
31.0.0.0/8
192.162.2.0/24
192.162.2.0/24
192.161.1.0/24
192.161.1.0/24
192.162.3.0/24
192.162.3.0/24
To disable RIP globally, use the

Configure RIP on interfaces

When you enable RIP globally on the system, interfaces meeting certain conditions start receiving RIP
routes. By default, interfaces that are enabled and configured with an IP address in the same subnet as the
RIP network address receive RIPv1 and RIPv2 routes and send RIPv1 routes.
Assign IP addresses to interfaces that are part of the same subnet as the RIP network identified in the
network
880 | Routing Information Protocol
(Figure
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:01:22, Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:01:22, Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
auto-summary
directly connected,Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:01:21, Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:00:27, Fa 0/0
auto-summary
[120/1] via 29.10.10.12, 00:01:22, Fa 0/0
auto-summary
no router rip
command syntax.
show ip rip database
385).
command in the CONFIGURATION mode.
command in the EXEC