Dell Force10 C150 Configuration Manual page 995

Dell Force10 provides additional MIB Objects to view copy statistics. These are provided in
Table 48-5. MIB Objects for Copying Configuration Files via SNMP
MIB Object
copyState
copyTimeStarted
copyTimeCompleted
copyFailCause
copyEntryRowStatus
To obtain a value for any of the MIB Objects in
Step Task
1 Get a copy-config MIB object value.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address
• index is the index value used in the
Note: You can use the entire OID rather than the object name. Use the form:
Figure 48-14.
Figure 48-13 and
These examples assume that:
• the server OS is Unix
• you are using SNMP version 2c
• the community name is public, and
• the file f10-copy-config.mib is in the current directory.
Note: In Unix, enter the command
OID
.1.3.6.1.4.1.6027.3.5.1.1.1.1.11
.1.3.6.1.4.1.6027.3.5.1.1.1.1.12
.1.3.6.1.4.1.6027.3.5.1.1.1.1.13
.1.3.6.1.4.1.6027.3.5.1.1.1.1.14
.1.3.6.1.4.1.6027.3.5.1.1.1.1.15
snmpset
Figure 48-14 are examples of using the command
snmpset
Values
1= running
2 = successful
3 = failed
Time value
Time value
1 = bad file name
2 = copy in progress
3 = disk full
4 = file exists
5 = file not found
6 = timeout
7 = unknown
Row status
Table 48-5:
command used to complete the copy operation.
snmpget
for help using this command.
Description
Specifies the state of the copy operation.
Specifies the point in the up-time clock
that the copy operation started.
Specifies the point in the up-time clock
that the copy operation completed.
Specifies the reason the copy request
failed.
Specifies the state of the copy operation.
Uses CreateAndGo when you are
performing the copy. The state is set to
active when the copy is completed.
[ |
OID.index mib-object.index
, as shown in
OID.index
to obtain a MIB object value.
Simple Network Management Protocol | 995
Table 48-5.