Configure PIM-DM
Configuring PIM-DM is a two-step process:
1. Enable multicast routing using the command
2. Enable PIM-DM on an interface. See page 750.
Related Configuration Tasks
•
Clear the PIM TIB using the command
•
Debug PIM-DM by displaying control activity (packets, events, timers, etc.) using the command
debug ip pim
Enable PIM-DM
To enable PIM-DM:
Step
Task
1
Enable multicast routing on the system.
2
Enable PIM-Dense Mode on each interface that will
participate in PIM-DM, as shown in
750
|
PIM Dense-Mode
from EXEC Privilege mode.
Figure
33-4.
ip multicast-routing
clear ip pim tib
from EXEC Privilege mode.
Command
ip multicast-routing
ip pim dense-mode
from CONFIGURATION mode.
Command Mode
CONFIGURATION
INTERFACE