Storing Last And Bad Pdus - Dell Force10 C150 Configuration Manual

Command Syntax
debug ip bgp
{ ip-address
peer-group-name
FTOS displays debug messages on the console. To view which debugging commands are enabled, use the
show debugging
Use the keyword no followed by the debug command To disable a specific debug command. For example,
to disable debugging of BGP updates, enter
no debug ip bgp
Use
undebug all
Use

Storing Last and Bad PDUs

FTOS stores the last notification sent/received, and the last bad PDU received on per peer basis. The last
bad PDU is the one that causes a notification to be issued. These PDUs are shown in the output of the
command
268 | Border Gateway Protocol IPv4 (BGPv4)
|
soft-reconfiguration
}
command in EXEC Privilege mode.
to disable all BGP debugging.
to disable all debugging.
show ip bgp neighbor
, as shown in
Command Mode Purpose
EXEC Privilege Enable soft-reconfiguration debug. Enable
soft-reconfiguration debug.
To enhance debugging of soft reconfig, use
the following command only when
route-refresh is not negotiated to avoid the
peer from resending messages:
bgp soft-reconfig-backup
In-BGP is shown via the
protocols
no debug ip bgp updates
Figure 10-34.
show ip
command.
command.