Configurable S,G Expiry Timers - Dell Force10 C150 Configuration Manual

Figure 34-2. Viewing PIM Neighbors Command Example
FTOS#show ip pim neighbor
Neighbor
Address
127.87.5.5
127.87.3.5
127.87.50.5
FTOS#
Display the PIM routing table using the command
shown in Figure
Figure 34-3. Viewing the PIM Multicast Routing Table
FTOS#show ip pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned,
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT,
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 192.1.2.1), uptime 00:29:36, expires 00:03:26, RP 10.87.2.6, flags: SCJ
Incoming interface: GigabitEthernet 4/12, RPF neighbor 10.87.3.5
Outgoing interface list:
GigabitEthernet 4/11
GigabitEthernet 7/13
(10.87.31.5, 192.1.2.1), uptime 00:01:24, expires 00:02:26, flags: FT
Incoming interface: GigabitEthernet 7/11, RPF neighbor 0.0.0.0
Outgoing interface list:
GigabitEthernet 4/11
GigabitEthernet 4/12
GigabitEthernet 7/13
--More--

Configurable S,G Expiry Timers

By default S, G entries expire in 210 seconds. You can configure a global expiry time (for all (S,G) entries)
or configure a expiry time for a particular entry. If both are configured, the ACL supercedes the global
configuration for the specified entries.
When an expiry time created, deleted, or updated, the changes are applied when the keep alive timer
refreshes.
To configure a global expiry time:
Task
Enable global expiry timer for S, G entries
Range 211-86400 seconds
Default: 210
Interface Uptime/Expires
Gi 4/11 01:44:59/00:01:16
Gi 4/12 01:45:00/00:01:16
Gi 7/13 00:03:08/00:01:37
34-3.
Ver DR
Prio/Mode
v2 1 / S
v2 1 / DR
v2 1 / S
show ip | ipv6 pim tib
[ ] from EXEC privilege mode, as
Command
ip pim sparse-mode
sg-expiry-timer
seconds
Command Mode
CONFIGURATION
PIM Sparse-Mode | 759