Dell Force10 C150 Configuration Manual page 907

Verify that EdgePort is enabled on a port using the
show config
privilege mode or the
show config
the command, as shown in
FTOS Behavior: Regarding
1 If the interface to be shutdown is a port channel then all the member ports are disabled in the hardware.
2 When a physical port is added to a port channel already in error disable state, the new member port will
also be disabled in the hardware.
3 When a physical port is removed from a port channel in error disable state, the error disabled state is
cleared on this physical port (the physical port will be enabled in the hardware).
reset linecard
4 The
state. The interface continues to be disables in the hardware.
The error disabled state can be cleared with any of the following methods:
shutdown
•Perform an
shutdown-on-violation
•Disable the
bpduguard |
[
•Disable spanning tree on the interface (
•Disabling global spanning tree (
Figure 44-7. EdgePort Enabled on Interface
FTOS(conf-if-gi-2/0)#show config
!
interface GigabitEthernet 2/0
no ip address
switchport
spanning-tree rstp edge-port
shutdown
FTOS(conf-if-gi-2/0)#
command from INTERFACE mode; Dell Force10 recommends using
Figure 44-7.
bpduguard shutdown-on-violation
command does not clear the error disabled state of the port or the hardware disabled
command on the interface.
command on the interface (
shutdown-on-violation
[ ]] ).
no spanning-tree
no spanning-tree
Indicates the interface is in EdgePort mode
show spanning-tree rstp
behavior:
no spanning-tree stp-id portfast
in INTERFACE mode).
in CONFIGURATION mode).
command from the EXEC
Rapid Spanning Tree Protocol | 907