Displaying Remote-Port Mirroring Configurations - Dell Force10 C150 Configuration Manual

Displaying Remote-Port Mirroring Configurations

To display the current configuration of remote port mirroring for a specified session, enter the
command in MONITOR SESSION configuration mode.
FTOS(conf-mon-sess-50)# show config
!
monitor session 50
source GigabitEthernet 1/2 destination remote-vlan 50 direction both mode Remote-Port-Mirroring
source vlan 4, vlan 11 - 12, destination remote-vlan 50 direction both mode Remote-Port-Mirroring
no disable
To display the currently configured source and destination sessions for remote port mirroring on a switch,
enter the
FTOS# show monitor session
SessionID
---------
50
50
20 Gi 1/3
10 remote-vlan 101
To display the current configuration of the reserved VLAN, enter the
FTOS(conf-if-gi-1/2)# show vlan
Codes: * - Default VLAN, G - GVRP VLANs,
P - Primary, C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM
*
R,G
828 | Port Monitoring
show monitor session
command in EXEC Privilege mode.
Source Destination
------ -----------
Gi 1/2 remote-vlan 50
Po 1 remote-vlan 50
remote-vlan 60
Gi 1/4
Status
1 Inactive
2 Active
Direction
---------
both
both
Session 50: Source session monitors a source port and source
port-channel using VLAN 50
both
Session 20: Source session monitors a source port configured
for flow-based monitoring using VLAN 50 at a destination
port-channel
N/A
Session 10: Destination session receives mirrored traffic on
VLAN 101 at a destination port
R - Remote Port Mirroring
Q Ports
T Gi 13/7
Mode
----
Remote-Port-Mirroring
Remote-Port-Mirroring
Remote-Port-Mirroring
Remote-Port-Mirroring
show vlan
command.
VLANs,
show config
Type
----
Port-based
Port-based
Flow-based
N/A