Dell Force10 C150 Configuration Manual page 827

Configure a Destination Session on Multiple Switches
Step Command Syntax
monitor session session-id
1
source remote-vlan vlan-id
2
destination { single-interface
| range { interface-list |
interface-range |
mixed-interface-list }}
tagged destination
3
{ single-interface | range
interface-range }
4 Repeat Steps 1 to 3 on other destination switches to configure additional destination ports for this session.
To delete one or more destination ports from a destination session, enter the
vlan-id destination
To change the reserved L2 VLAN used in the destination session, you must first remove all destination
ports. Then delete the current VLAN by entering the
command and re-enter the
vlan-id
configure the new VLAN ID.
To reconfigure destination ports as untagged ports, enter the
Command Mode
CONFIGURATION
MONITOR SESSION
MONITOR SESSION
command.
monitor session session-id source remote-vlan
Task
Configure the destination session for remote port
mirroring and enter Monitor Session configuration
mode.
Associate the reserved L2 VLAN used to transport
mirrored traffic with this destination session and
configure the destination ports to which an analyzer
is a connected.
single-interface is one of the following values:
gigabitethernet slot/port
tengigabitethernet slot/port
range interface-list specifies multiple interfaces
separated by a comma and space: single-interface,
single-interface, single-interface...
range interface-range specifies one of the
following interface ranges:
gigabitethernet slot/first_port-last_port
tengigabitethernet slot/first_port-last_port
A space is required before and after the dash (-).
range mixed-interface-list specifies single
interfaces and interface ranges in any order:
single-interface, interface-range, single-interface...
(Optional) Configure destination ports so that the
reserved VLAN tag is added to the monitored
traffic sent to an analyzer.
Default: Destination ports send untagged packets so
that the reserved VLAN ID is removed and the
original monitored packet is analyzed.
single-interface is one of the following values:
gigabitethernet slot/port
tengigabitethernet slot/port
range interface-range specifies one of the
following interface ranges:
gigabitethernet slot/first_port-last_port
tengigabitethernet slot/first_port-last_port
no monitor session session-id source remote-vlan
untagged destination
no source remote-vlan
command to
command.
Port Monitoring | 827