Igmp Snooping; Igmp Snooping Implementation Information; Configuring Igmp Snooping; Enabling Igmp Immediate-Leave - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

IGMP Snooping

Multicast packets are addressed with multicast MAC addresses, which represent a group of devices, rather
than one unique device. Switches forward multicast frames out of all ports in a VLAN by default, even
though there may be only some interested hosts, which is a waste of bandwidth. IGMP Snooping enables
switches to use information in IGMP packets to generate a forwarding table that associates ports with
multicast groups so that when they receive multicast frames, they can forward them only to interested
receivers.

IGMP Snooping Implementation Information

IGMP Snooping on FTOS uses IP multicast addresses not MAC addresses.
IGMP Snooping is not supported on stacked VLANs.
IGMP Snooping is supported on all S-Series stack members.
IGMP Snooping reacts to STP and MSTP topology changes by sending a general query on the
interface that transitions to the forwarding state.

Configuring IGMP Snooping

Configuring IGMP Snooping is a one-step process. That is, enable it on a switch using the command
igmp snooping enable
running-config
a VLAN using the command
Figure 19-9. Enabling IGMP Snooping
FTOS(conf)#ip igmp snooping enable
FTOS(conf)#do show running-config igmp
ip igmp snooping enable
FTOS(conf)#
Related Configuration Tasks
Enabling IGMP Immediate-leave on page 412
Disabling Multicast Flooding on page 413
Specifying a Port as Connected to a Multicast Router on page 413
Configuring the Switch as Querier on page 413

Enabling IGMP Immediate-leave

Configure the switch to remove a group-port association upon receiving an IGMP Leave message using the
command
show config
412
|
Internet Group Management Protocol
from CONFIGURATION mode. View the configuration using the command
from CONFIGURATION mode, as shown in
no ip igmp snooping
ip igmp fast-leave
from INTERFACE VLAN mode. View the configuration using the command
from INTERFACE VLAN mode, as shown in
Figure
19-9. You can disable snooping on for
from INTERFACE VLAN mode.
Figure
19-10.
ip
show

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents