View Cam Profiles; View Cam-Acl Settings - Dell Force10 C150 Configuration Manual

View CAM Profiles

View the current CAM profile for the chassis and each component using the command
as shown in Figure
component reload.
Figure 11-4. Viewing CAM Profiles on E-Series TeraScale
FTOS#show cam-profile
-- Chassis CAM Profile --
CamSize
Profile Name
L2FIB
L2ACL
IPv4FIB
IPv4ACL
IPv4Flow
EgL2ACL
EgIPv4ACL
Reserved
FIB : 0
ACL : 0
Flow : 0
EgACL : 0
MicroCode Name
--More--
View a brief output of the command
show running-config cam-profile
The command
Note: If you select the CAM profile from CONFIGURATION mode, the output of this command does not
reflect any changes until you save the running-configuration and reload the chassis.
Figure 11-5. Viewing CAM Profile Information in the Running-configuration
FTOS#show running-config cam-profile
!
cam-profile default microcode default
FTOS#

View CAM-ACL settings

View the current cam-acl settings for the C-Series and S-Series systems chassis and each component using
show cam-acl
the command
11-4. This command also shows the profile that will be loaded upon the next chassis or
: 18-Meg
: Current Settings : Next Boot
: Default : Default
: 32K entries : 32K entries
: 1K entries : 1K entries
: 256K entries : 256K entries
: 12K entries : 12K entries
: 24K entries : 24K entries
: 1K entries : 1K entries
: 1K entries : 1K entries
: 8K entries : 8K entries
entries : 0 entries
entries : 0 entries
entries : 0 entries
entries : 0 entries
: Default : Default
show cam-profile
, as shown in Figure
summary
using the
shows the current profile and microcode
11-6.
show cam-profile
option.
(Figure 11-5).
Content Addressable Memory | 291
,