Add Or Remove A Port Channel From A Vlan - Dell Force10 C150 Configuration Manual

Figure 20-16. Command Example from Reassigning an Interface to a Different Port Channel
FTOS(conf-if-portch)#show config
!
interface Port-channel 4
no ip address
channel-member GigabitEthernet 1/8
no shutdown
FTOS(conf-if-portch)#no chann gi 1/8
FTOS(conf-if-portch)#int port 5
FTOS(conf-if-portch)#channel gi 1/8
FTOS(conf-if-portch)#sho conf
!
interface Port-channel 5
no ip address
channel-member GigabitEthernet 1/8
shutdown
FTOS(conf-if-portch)#
Configure the minimum oper up links in a port channel (LAG)
You can configure the minimum links in a port channel (LAG) that must be in "oper up" status for the port
channel to be considered to be in "oper up" status. Use the following command in the INTERFACE mode:
Command Syntax
minimum-links
Figure 20-17
Figure 20-17. Example of using the minimum-links Command
FTOS#config t
FTOS(conf)#int po 1
FTOS(conf-if-po-1)#minimum-links 5
FTOS(conf-if-po-1)#

Add or remove a port channel from a VLAN

As with other interfaces, you can add Layer 2 port channel interfaces to VLANs. To add a port channel to a
VLAN, you must place the port channel in Layer 2 mode (by using the
434 | Interfaces
Command Mode
INTERFACE
number
displays an example of configuring five minimum "oper up" links in a port channel.
Purpose
Enter the number of links in a LAG that must be in "oper
up" status.
Default: 1
switchport
command).