Assign a Static IPv6 Route
IPv6 Static Routes
are supported on platforms
ipv6 route
Use the
command to configure IPv6 static routes.
Command Syntax
ipv6 route
prefix type {slot/
port} forwarding router tag
Telnet with IPv6
IPv6 Telnet
is supported on platforms
The Telnet client and server in FTOS support IPv6 connections. You can establish a Telnet session directly
to the router using an IPv6 Telnet client, or an IPv6 Telnet connection can be initiated from the router.
Note: Telnet to link local addresses is not supported.
c e s
Command Mode
CONFIGURATION
c e s
Purpose
Set up IPv6 static routes
prefix: IPv6 route prefix
type {slot/port}: interface type and slot/port
forwarding router: forwarding router's address
tag: route tag
interface
Enter the keyword
interface and slot/port information:
•
For a 10/100/1000 Ethernet interface, enter the
GigabitEthernet
keyword
port information.
•
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port
information.
•
For a 10 Gigabit Ethernet interface, enter the
TenGigabitEthernet
keyword
slot/port information.
•
For a loopback interface, enter the keyword
loopback
followed by the loopback number
•
For a linecard interface, enter the keyword
linecard
followed by the slot number
•
For a port-channel interface, enter the keyword
port-channel
followed by the port-channel
number
•
For a VLAN interface, enter the keyword
followed by the VLAN ID
•
For a Null interface, enter the keyword
followed by the Null interface number
followed by the type of
followed by the slot/
followed by the
vlan
null
IPv6 Addressing | 499